Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - 1985 CCX

Pages: 1 2 [3] 4 5 ... 7
31
Correct not much room under the fender.  I already have a typical Cobra with race wheels etc so my choice for tires is Goodyear Power Cushion in pics above.
They were the street tire in the 60's and will handle well, as I am a stock 225hp stability should be fine. 
Will plan to wrap exhaust as dropping the under fender heat can only be a good factor for tires, alloy body and paint.

32
Magnesium FIA
Just need the sneakers

33
Michael

I know this is a long expired thread.....
Did you ever perform this task?  I am planning to repack bearings to avoid dry bearings and spindle fracture this month.
35year old car, 8000 miles indicates its sat for some time.

34
Awesome!
Car looks great, hope you enjoy it.

35
Ok, roadblock
With the current exhaust the sunburst gets tire within 1” of the SS muffler.
The FIA allows for the same 1.5” that the MKIV wheel does.
Will need to do more measuring but may use mag FIA ?
15” fills wheel-well out nicely.

Thoughts?

36
Now that you have made this change would you:

a) Say it was worth it to go FE?
b) If you have to do over would you pick a small block Nascar type motor as it gives the power and bolt up to stock position?

BTW I love the FE change...

37
Yes
I’ll have to go measure.
Think the same as the 60’s car as I have one of those too
With narrower tire should allow it to work?
I’ll put the wheels on this weekend

38
Exactly
I sent original boss to them so they could adjust accordingly

39
OEM Autokraft.
Just exactly like the ones shown


Would you part with these?
I’ll pm, done.....

40
The Power Cushion

41
Newly cast wheel

42
New project
Add Sunburst wheels to my MKIV
The trick will be to retain the original exhaust ......
Offset and tire size will be key
Planning Goodyear Power Cushion
Newly cast wheels

43
Still looking for OEM sun visors

44
Finally the wheel installed
The new boss and offset of the wheel works great
This finished bolt on change allows reversal to the OEM at any stage.
Cannot wait till Spring!

Next, Sunburst 15” wheels ......

45
Moto-Lita did a great job!
Pictured is the original boss and the new.
Attached the 16” wheel.
Ready to install

Pages: 1 2 [3] 4 5 ... 7