Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - jmohara

Pages: 1 ... 5 6 [7] 8
91
I have this in for a rebuild and am still hoping someone can confirm that its a Salisbury 4HU Power-Lok unit. I have the specs for that, and gave them to the builder - so I hope its the right one :-)

92
OK thanks guys - I know just the man for that job :-) Appreciate the guidance.
   Michael

93
Mk IV, Superblower, CRS and other Continuation Cars Forum / Rear Disks
« on: December 30, 2016, 22:25:46 »
Anyone any thoughts for a Cobra novice?

94
Mk IV, Superblower, CRS and other Continuation Cars Forum / Trim piece
« on: December 26, 2016, 16:55:23 »
Thanks Luke. Let me know. Michael

95
I know its the same unit as a Jaguar - but I need the actual type number to get all the clearances etc. Anyone confirm its a Salisbury 4HU Power-Lok?

96
OK I am coming to the end of my MKIV rebuild. When I got the car the trunk lid interior material was lying on the floor and the number plate light wire was dangling into the space. I'm trying to figure out what order these things go on.
   Does the wire attach to the trunk lid and then the material covers it all?
   Or does the material attach to the trunk lid and then the wire attaches on the outside?
   Any pictures would be great.
   Thanks
   M

97
I have a little pressure switch in the drivers rear arch that activates the brake lights. Seems to have failed. Anyone know the part number or the source of the original part?

98
Really need one - can anyone help me out?
   Thanks
   Michael

99
Hi all,
   I need a handbrake lever return spring and 2 of the thrust springs from the rear calipers. I know they are Peugeot 504/5 calipers, but can't find the part numbers for the springs. Anyone any ideas?
   Michael

100
I know its a Mercedes unit from the W123, but anyone know where I can get one. Really need it!!!!
   M

101
Hi all,
   Just to say if you are looking for a new throttle cable, Speedy Cables in Swansea did an excellent job for me, matching the original for 30 UK pounds. Took about two weeks. Thanks to Alan Faulkner Stevens for the excellent tip.
   Michael

102

   
   Hoping this picture is showing.
   
   Refitting Differential. Just realized the top cradle bracket is different front and back and don't know what way to put it on.
   
   Can anyone help quick?
   
   I have it on one way at the moment but no idea if thats correct.
   
   M

103
Hi all,
   
   I have completed my electrical restoration of my early MKIV - made harder by someone butchering a load of wires at some point.
   Anyway I am down to 2 questions and hoping for help.
   
   1. I have a mysterious spare white wire. It leaves the fuse block, goes out the side of the enclosure into the wing area where the side vents are, heads upwards and then comes back into the inside of the car close to the wiper motor. The mystery is that I just have a bare live wire and can't see what its was meant to connect to. Any ideas?
   
   2. I have a ldoor buzzer circuit on the drivers side, but I can't for the life of me find any door switches..Are they hidden somewhere and I am missing the obvious? Or was it fitted and not used? It is beside the seat belt buzzer which does work.
   
   THANKS!!!!
   
   Michael

104
Hi all,
   This has been covered a bit, but I am fitting JBA shorty headers on Left hand drive 1985 MKIV. The passenger side fit really nice.
   Drivers side appear very tight.
   Some post seem to indicate they had to cut them. others seem to have got them to fit.
   Any advice would be amazing.
   Thanks
   Michael

105
Suggestions on where to get these?
   Michael

Pages: 1 ... 5 6 [7] 8