AC Owners Club Forum

AC Owners Club Forum => 428 Frua Forum => Topic started by: MkIV Lux on April 02, 2007, 14:04:41

Title: Spinner Tightening / Removal tool
Post by: MkIV Lux on April 02, 2007, 14:04:41
Here is the right tool for spinners / central nuts:
   
   Found this past week at Germany's largest historic motor show, Techno-Classica at Essen.
   
   (http://i172.photobucket.com/albums/w34/MkIVLux/Spinnertoolc.jpg)
   (http://i172.photobucket.com/albums/w34/MkIVLux/Spinnertoolb.jpg)
   (http://i172.photobucket.com/albums/w34/MkIVLux/Spinnertoola.jpg)
   (http://i172.photobucket.com/albums/w34/MkIVLux/Spinnertool.jpg)
   
   Sold by Oldtimer-Tools in D-31199 Diekholzen (mk@oldtimertools.de    www.oldtimertools.com).
   High quality tool works with any wrench, and is suitable for deep bedded rims.
   They have various models suitable for 2 or 3 eared spinners, respectively central nuts.
   For AC Cobras / GT40 and thelike, two sizes are available: somewhat narrower dents for the lighter aluminium spinners, somewhat deeper dents for the large brass spinners. They do not yet have a tool for the AC hexagonal central nut.
   Priced at 250 € (inclusive VAT) plus P&P.
   
   Regards
   Constant