I am in the process of fitting the front and rear anti roll bars to my car. Some of you may know that my car was made by AC Cars in 2001 however it was never completed before AC folded. My car is chassis number: ACSB7020- (a Superblower)
I have over the last few years been steadily completing the build with the expert assistance of Steve Gray from Brooklands Motor Company and help and advise from members of this forum. The car is really coming on now and I hope it may be finished next year!
Below I will detail the parts and hopefully show the fitment of the anti roll bars.
I will start with the front set-up;
The first image shows the front off-side suspension, you may be able to see the offside chassis mount for the front anto roll bar. There is a second identical attachment on the nearside. The second image is a more close up picture.
The following image shows the front anti roll bar and fixings;
This next image shows a closer view of the eye end joints, I obtained these parts from Autosport Bearings here in the UK and I may have the part numbers if anyone needs them. One eye end fits into the end of the anti roll bar with a 7/16 UNF bolt (if memory serves me right), the other end fixes onto a mounting point on the lower wish bone (A arm)
The next image shows the chassis mounting blocks. They are two piece items, one side has a grease nipple. They are attached to the chassis with 3/8 UNF x 2 1/2 inch bolts.
Tomorrow I hope to fit this to the car so will post further images if all goes well.
The rear bar set-up I similar to the front.
The image below shows the bar.The bar is narrower than the front one;
It is attached to the chassis with two brackets (Ford items- I can supply the part numbers if required. The next images shows the brackets. I have yet to buy the bushes but they won't be a problem to source;
The next image shows the end fitting, they are very similar to the front but the attachment bolts are smaller (i think 3/8 UNF of 5/16 UNF, but would have to check for you if required)
I will attach this to the car once I have the bushes and will post images of it installed.
The anti roll bars themselves came from John Owen from AC Cars, which I bought off him a few years ago. I had them powder coated this last few days as they were a bit tatty. All the other components are from Autosport Bearings.
Hope this has been of some help.
Gary