Hello all!
I reveved some new parts from Burlen and installed them yesterday ( new float chambers needle valve, float chamber gaskets etc..).
When I reconnected the fuel line i found a very bad leak! it is at the frst carburetor joint, where the copper pipe comes from the pump.
I had disconnected this joint before, and it had never leaked.
I am missing a rubber seal? or it should be just the nut and the brass ferrule?
I have noticed the brass ferrule moves around on the copper pipe. is it normal? Should it move or not?
Do you have any suggestion for stopping this leak? Should i change this pipe?
Thanks!!!
Eddie