AC Owners Club Forum
AC Owners Club Forum => Mk IV, Superblower, CRS and other Continuation Cars Forum => Topic started by: lonzcllns on September 15, 2017, 14:13:13
-
My MKIV was built in Aug 1985 however the engine doesn't appear to be a 1985 model. Does anyone know where the date codes are on the engine block? I recently had to buy a new ignition coil and I had to get a coil for an '83 5.0 L Mustang HO to match my old coil.
-
Block casting code: looking aft the code should be cast at the block/starter motor interface at the 2 o'clock position
Date code: should be below the block code and will probably be impossible to see without removing the starter
Engine serial number: should be stamped or cast into the block about 4" back (mid-point of the starter) about 2 o'clock position. Ford reman block shown below
Note:
These numbers are a PIA to get to
In all likelihood they will be covered in grime
Try having the car on a hoist (engine/exhaust cold) and taking photos with a good mobile phone
Try using a mirror
Last resort - take the starter out
All of this is possible if you are a skinny bugger like me and have a hinge part-way between wrist and elbow [:)]
(https://dl.dropbox.com/s/vsgwlstjl3fnb1v/Block%20ID.jpg?dl=0)