5
« on: April 02, 2013, 19:15:57 »
On either the Hawk over rider or the Small Ford Spares over rider - how do you guys keep the over riders from rotating about the bolt or stud that holds the over rider onto the bracket? Attaching by only 1 fastener enables the over rider to rotate the fastener no matter how tight you tighten the fastener - how do you keep this from happening? If the over rider was being fastened/locked to a bumper this would not be a problem but this normally isn't done with most Ace Aces as the over rider is out there by itself attached to the bracket.